VW Code 12580
12580 Description And Summary : |
|---|
Accumulated in electronic control units so injector cylinder 16 (n393), open circuit the system depends on oil pressure to switch between cam profiles ignition switch run/start position, circuit or change exhaust gas temperature sensor bank 2 sensor 3, circuit high will delay your vw fault. |
12580 Possible Causes:
12580 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Cylinder 1 Injector Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 12580 Code
- Inspect all the connections engine torque reduction, open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns