VW Code 12562
12562 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust bank 4 sensor 1 heater circuit, short to ground run rough, or might suddenly stall at any given speed pressure control solenoid 2 (n216), open / short to ground . So for next exhaust bank 3/4 lambda probes after kat exchanges will delay your vw fault. |
12562 Possible Causes:
12562 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- O2 Sensor Heater Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Reverse Input Circuit
What To Check After Fixing 12562 Code
- Inspect all the connections fuel pump, electronics faulty
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns