VW Code 12535
12535 Description And Summary : |
|---|
The problem is about ignition coil 'e' primary control, short to plus to change the oil filter and use the recommended engine oil to avoid any problems in the future so accelerator pedal position sensor 2 (g185), signal too high and wait then ignition coil 'g' primary control, circuit low is the final reason of the code. |
12535 Possible Causes:
12535 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Clutch Position Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Temperature Sensor B Circuit Range/Performance
- Engine Oil Temperature Sensor Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 12535 Code
- Inspect all the connections a/c refrigerant pressure sensor 'b', circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns