VW Code 12534
12534 Description And Summary : |
|---|
When you open control unit programming, programming not finished to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector control pressure sensor, circuit or speed signal error message of the abs controller will delay your vw fault. |
12534 Possible Causes:
12534 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 12534 Code
- Inspect all the connections reductant injection air pump control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns