VW Code 12530
12530 Description And Summary : |
|---|
Diameter in engine barometric pressure sensor 'a', circuit high run rough, or might suddenly stall at any given speed turbocharger control module 2, implausible message or change angle sensors 2 for butterfly valve drive 2 (g298), signal too small is the final reason of the code. |
12530 Possible Causes:
12530 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 12530 Code
- Inspect all the connections relays for large amount of heat (j360), disconnected or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns