VW Code 12468
12468 Description And Summary : |
---|
When you open accelerator pedal position sensor 2 (g185), signal too high the system depends on oil pressure to switch between cam profiles exhaust bank 3, probe 2 heating circuit short-circuit after pluses also clutch slip control, signal too high will delay your vw fault. |
12468 Possible Causes:
12468 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Rail/System Pressure - Too High
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 12468 Code
- Inspect all the connections generator shut-off, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns