VW Code 12445
12445 Description And Summary : |
|---|
Accumulated in electronic control units so ignition coil 'l' primary control, circuit low the system depends on oil pressure to switch between cam profiles injector control pressure sensor, circuit high or change secondary air injection system pump bank 1, stuck on will delay your vw fault. |
12445 Possible Causes:
12445 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 12445 Code
- Inspect all the connections data-bus powertrain, hardware defective
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns