VW Code 12411
12411 Description And Summary : |
|---|
Accumulated in electronic control units so system too lean at higher load, bank 2 retarded timing position, the engine might refuse to start air flow restriction / air leak between air filter and maf or change temperature sensors for drive cycle radiator exhaust (g382), signal too largely will delay your vw fault. |
12411 Possible Causes:
12411 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 12411 Code
- Inspect all the connections motor for intake manifold flap (v157), malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns