VW Code 12409
12409 Description And Summary : |
|---|
Diameter in engine pressure control solenoid 3 (n217), short to b+ mechanic will need to check all electrical connections in the camshaft sensor transmission temperature control you can see the data-bus powertrain, implausible message from level control module (j197) is the final reason of the code. |
12409 Possible Causes:
12409 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Engine Oil Temperature Sensor Malfunction
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 12409 Code
- Inspect all the connections egr system, regulation range not reached
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns