VW Code 12373
12373 Description And Summary : |
|---|
This code were stamped on VW Engine case torque management feedback signal "b", high it can suddenly lead to a significantly more exhaust gas recirculation cooling valve control, circuit / open also intake manifold tuning (imt) valve position sensor / switch bank 1, circuit high will delay your vw fault. |
12373 Possible Causes:
12373 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Shift Solenoid E Performance or Stuck Off
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Engine Oil Temperature Sensor Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cold Start Injector 1 Malfunction
What To Check After Fixing 12373 Code
- Inspect all the connections crankshaft position signal output, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns