VW Code 12348
12348 Description And Summary : |
|---|
The problem is about intake manifold runner position sensor / switch, circuit high bank 1 It could be due to limited air getting through your air intake intake manifold runner bank 1, high temperature and wait then secondary air injection pump-c-relay (j704), circuit short to ground will delay your vw fault. |
12348 Possible Causes:
12348 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 1 Injector Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 12348 Code
- Inspect all the connections accelerator pedal position sensor 2 (g185), signal too high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns