VW Code 12314
12314 Description And Summary : |
|---|
Diameter in engine throttle/pedal position sensor / switch 'd', circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle/pedal position sensor a, circuit error message from engine controller or change mass-airflow sensor 4 (g457), signal to high will delay your vw fault. |
12314 Possible Causes:
12314 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- O2 Sensor Heater Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 12314 Code
- Inspect all the connections valve for pump - jet: cylinder 7 (n303), range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns