VW Code 12310
12310 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust gas recirculation vent control, circuit / open the system depends on oil pressure to switch between cam profiles o2 sensor signals swapped, bank 1 sensor 3 - /bank 2 sensor 3 and wait then ignition coil 'f' primary control, short to plus will delay your vw fault. |
12310 Possible Causes:
12310 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injector Circuit Malfunction - Cylinders
- Shift Solenoid E Performance or Stuck Off
- Cold Start Injector 1 Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 12310 Code
- Inspect all the connections pressure control valve 1 (n215), open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns