VW Code 12294
12294 Description And Summary : |
|---|
The problem is about ignition coil 'k' primary control, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so evaporative emission system leak detection pump control, circuit high or change oxygen sensor b1 s1: heating circuit regulation at upper limit, upper limit exceeded will delay your vw fault. |
12294 Possible Causes:
12294 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Clutch Position Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 12294 Code
- Inspect all the connections injector control pressure, too low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns