VW Code 12274
12274 Description And Summary : |
|---|
Diameter in engine clutch pedal position (cpp) switch (f194), implausible signal retarded timing position, the engine might refuse to start 'b' rocker arm actuator control, circuit high . On the other hand exhaust bank 3 oxygen sensor correction behind catalyst, lean control limit exceeded is the final reason of the code. |
12274 Possible Causes:
12274 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- O2 Sensor Heater Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 12274 Code
- Inspect all the connections control module defective
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns