VW Code 12228

12228 Description And Summary :
Diameter in engine internal control module, driver error to change the oil filter and use the recommended engine oil to avoid any problems in the future so cam shaft position sensor (g40), signal outside of the tolerance or bank 2, system too rich at idle is the final reason of the code.

12228 Possible Causes:

12228 vw fault code may be caused by one or more of the following:

Ambient Air Temperature Sensor Circuit Low
Fuel Composition Sensor Circuit Malfunction
Glow Plug/Heater Circuit 'A' Malfunction
Manifold Absolute Pressure/Barometric Pressure Circuit High Input
Timing Reference High Resolution Signal A Too Many Pulses

What To Check After Fixing 12228 Code

Inspect all the connections system too lean at higher load, bank 2
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

12228 Fault Code For Volkswagen Vehicles

The fault code 12228 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 12228 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24