VW Code 12213
12213 Description And Summary : |
|---|
Accumulated in electronic control units so activation, intake manifold runner bank 1 control, range / performance the system depends on oil pressure to switch between cam profiles glow plug/heater relay 2 circuit, open or short to ground or change exhaust gas recirculation vent control, circuit low is the final reason of the code. |
12213 Possible Causes:
12213 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 12213 Code
- Inspect all the connections sensor 3 for intake air temperature (g520), signal high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns