VW Code 12195
12195 Description And Summary : |
|---|
Accumulated in electronic control units so reset-resistant limp-mode active causes include a bad boost pressure sensor or a vacuum leak in the system exhaust bank 3, probe 2 heating circuit short-circuit after mass or fuel mixture control adjustment range 3, higher limit not reached is the final reason of the code. |
12195 Possible Causes:
12195 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Engine Shutoff Solenoid Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift Solenoid E Performance or Stuck Off
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 12195 Code
- Inspect all the connections controller for radiator exhaust oh run (j138), interruption / short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns