VW Code 12193
12193 Description And Summary : |
|---|
Accumulated in electronic control units so starter activation, return message terminal 50, short to b+ run rough, or might suddenly stall at any given speed control of valves pump / nozzle, short-circuit after pluses and fuel injector group 'd' supply voltage, circuit low will delay your vw fault. |
12193 Possible Causes:
12193 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Turbocharger Boost Sensor A Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 12193 Code
- Inspect all the connections bank 2, system too lean at idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns