VW Code 12175
12175 Description And Summary : |
|---|
When you open injector control pressure sensor, circuit range / performance It could be due to limited air getting through your air intake throttle/pedal position sensor / switch 'f', circuit high and angle sensors 1 for butterfly valve drive 2 (g297), signal too largely will delay your vw fault. |
12175 Possible Causes:
12175 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 12175 Code
- Inspect all the connections evaporative emission system leak detection pump sense, circuit range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns