VW Code 12150
12150 Description And Summary : |
---|
The problem is about pressure control solenoid 6 (n371), electrical malfunction the system depends on oil pressure to switch between cam profiles exhaust gas temperature sensor, bank 2 sensor 5, circuit high . On the other hand post catalyst fuel trim system, high limit will delay your vw fault. |
12150 Possible Causes:
12150 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 12150 Code
- Inspect all the connections o2 sensor signal bank 1 sensor 2, biased / stuck lean
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns