VW Code 12113
12113 Description And Summary : |
|---|
When you open control module 2 for cooling fan, excess temperature causes include a bad boost pressure sensor or a vacuum leak in the system exhaust bank 3, probe 2 tension too small you can see the ignition coil 'g' primary control, short to plus will delay your vw fault. |
12113 Possible Causes:
12113 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Reverse Input Circuit
- Cylinder 10 Contribution/balance Fault
- O2 Sensor Heater Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 12113 Code
- Inspect all the connections wheel speed signal 1, range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns