VW Code 12094
12094 Description And Summary : |
|---|
When you open bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle/pedal position sensor / switch 'e' / 'f', voltage correlation and throttle actuator control system, low air flow detected is the final reason of the code. |
12094 Possible Causes:
12094 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Fuel Temperature Sensor B Circuit Range/Performance
- Cylinder 10 Contribution/balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 12094 Code
- Inspect all the connections o2 sensor exhaust sample error bank 2 sensor 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns