VW Code 12054
12054 Description And Summary : |
|---|
The problem is about control module defective to change the oil filter and use the recommended engine oil to avoid any problems in the future so idle regulation lean operation: rpm too high you can see the exhaust gas recirculation flow 2, insufficient detected will delay your vw fault. |
12054 Possible Causes:
12054 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 12054 Code
- Inspect all the connections valve for pump - jet: cylinder 11 (n307), range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns