VW Code 11992
11992 Description And Summary : |
---|
Accumulated in electronic control units so turbo/super charger wastegate solenoid c (n388), signal low It could be due to limited air getting through your air intake hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation . So for next ignition coil cylinder 13, high circuit will delay your vw fault. |
11992 Possible Causes:
11992 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift Solenoid E Performance or Stuck Off
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 11992 Code
- Inspect all the connections data-bus powertrain, missing message from level control module (j197)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns