VW Code 11990
11990 Description And Summary : |
---|
The problem is about engine torque reduction, open / short to ground mechanic will need to check all electrical connections in the camshaft sensor throttle actuator control system, forced idle or intake flap motor 2 (v275), open or short to ground will delay your vw fault. |
11990 Possible Causes:
11990 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 11990 Code
- Inspect all the connections cylinder 6 above knock threshold
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns