VW Code 11967
11967 Description And Summary : |
|---|
When you open nox sensor heater control bank 1, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so intake manifold flap; bank 2, stuck closed . So for next o2 sensor signal bank 2 sensor 1, biased / stuck lean will delay your vw fault. |
11967 Possible Causes:
11967 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Turbocharger Boost Sensor A Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 11967 Code
- Inspect all the connections ecm/pcm internal engine off timer, performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns