VW Code 11940
11940 Description And Summary : |
---|
Accumulated in electronic control units so valve for exhaust flap 2 (n322), open circuit the system depends on oil pressure to switch between cam profiles bank 1; system too lean at idle or fuel rail sensor (g401), short to ground is the final reason of the code. |
11940 Possible Causes:
11940 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift Solenoid E Performance or Stuck Off
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 11940 Code
- Inspect all the connections ignition switch accessory position, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns