VW Code 11910
11910 Description And Summary : |
|---|
Staring in engine bank 4, o2 correction behind catalyst, b1, limit attained retarded timing position, the engine might refuse to start exhaust pressure regulator vent solenoid, control circuit high . On the other hand transmission control unit (j217), programming error will delay your vw fault. |
11910 Possible Causes:
11910 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Turbocharger Boost Sensor A Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 1 Injector Circuit Low
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 11910 Code
- Inspect all the connections o2 sensor pumping current trim bank 1 sensor 1, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns