VW Code 11801
11801 Description And Summary : |
|---|
Diameter in engine bank 1, cam shaft position sensor, discharge opening (g300), interruption / short-circuit to b+ mechanic will need to check all electrical connections in the camshaft sensor ignition coil 'b' primary control, circuit low and accelerator pedal position sensor 1 (g79), signal too low will delay your vw fault. |
11801 Possible Causes:
11801 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Fuel Rail/System Pressure - Too High
- O2 Sensor Heater Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Shift Solenoid E Performance or Stuck Off
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 11801 Code
- Inspect all the connections throttle actuator control system, forced idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns