VW Code 11800
11800 Description And Summary : |
|---|
The problem is about relays for large amount of heat (j360), disconnected or short to ground It could be due to limited air getting through your air intake rough road / acceleration sensor, electrical malfunction and wait then turbocharger speed sensor, circuit high will delay your vw fault. |
11800 Possible Causes:
11800 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Shift Solenoid E Performance or Stuck Off
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cold Start Injector 1 Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 11800 Code
- Inspect all the connections bank 2, exhaust cam wave position sensor (g301) / crankshaft position sensor (g28), wrong allocation
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns