VW Code 11741
11741 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust bank 3, probe 2 tension too largely run rough, or might suddenly stall at any given speed ignition coil cylinder 15, low circuit and manifold absolute pressure / mass air flow - throttle position correlation at idle will delay your vw fault. |
11741 Possible Causes:
11741 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 11741 Code
- Inspect all the connections valve 2 for load pressure control (n274), short-circuit after pluses
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns