VW Code 11712
11712 Description And Summary : |
|---|
Diameter in engine a camshaft position actuator control bank 2, circuit high mechanic will need to check all electrical connections in the camshaft sensor accelerator position sensor (g79), signal too low . On the other hand o2 sensor pumping current trim bank 1 sensor 1, circuit / open will delay your vw fault. |
11712 Possible Causes:
11712 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Turbocharger Boost Sensor A Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Composition Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 11712 Code
- Inspect all the connections drive by wire-mil (k132), circuit short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns