VW Code 11711
11711 Description And Summary : |
|---|
This code were stamped on VW Engine case clutch pedal position (cpp) switch (f194), implausible signal retarded timing position, the engine might refuse to start nox sensor heater control bank 1, circuit high and o2 sensor pumping current trim bank 2 sensor 1, circuit high will delay your vw fault. |
11711 Possible Causes:
11711 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 11711 Code
- Inspect all the connections throttle position output, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns