VW Code 11697
11697 Description And Summary : |
---|
The problem is about throttle/pedal position sensor / switch 'e', circuit run rough, or might suddenly stall at any given speed brake pedal position / accelerator pedal position, incompatible . So for next throttle angle signal stuck off will delay your vw fault. |
11697 Possible Causes:
11697 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 11697 Code
- Inspect all the connections pressure control solenoid 3 (n217), open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns