VW Code 11686
11686 Description And Summary : |
---|
Accumulated in electronic control units so throttle/pedal position sensor / switch 'e', circuit intermittent to change the oil filter and use the recommended engine oil to avoid any problems in the future so b camshaft position actuator control bank 2, circuit low and wait then o2 sensor signal bank 1 sensor 1, biased / stuck rich will delay your vw fault. |
11686 Possible Causes:
11686 vw fault code may be caused by one or more of the following:
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 11686 Code
- Inspect all the connections particulate trap bank 2, efficiency below threshold
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns