VW Code 11642
11642 Description And Summary : |
|---|
Staring in engine hydraulic pressure sensor 2 too low to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition coil 'j' primary control, circuit low and wait then 'a' rocker arm actuator control, circuit / open will delay your vw fault. |
11642 Possible Causes:
11642 vw fault code may be caused by one or more of the following:
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 11642 Code
- Inspect all the connections throttle/pedal position sensor a, circuit error message from engine controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns