VW Code 11608
11608 Description And Summary : |
---|
Accumulated in electronic control units so change-over valve for intake manifold flap 2, performance or stuck off the system depends on oil pressure to switch between cam profiles control circuit for controller for turbocharger 2 (j725): electrical malfunction or change transmission request torque reduction, implausible is the final reason of the code. |
11608 Possible Causes:
11608 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor B Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Engine Oil Temperature Sensor Malfunction
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 11608 Code
- Inspect all the connections pressure control solenoid 5 (n233), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns