VW Code 11545
11545 Description And Summary : |
|---|
Diameter in engine intake manifold runner position sensor / switch, circuit range / performance bank 2 run rough, or might suddenly stall at any given speed fuel supply heater, control circuit / open you can see the valve for pump - jet: cylinder 9 (n305), circuit low input will delay your vw fault. |
11545 Possible Causes:
11545 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Cylinder 4 Contribution/Balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Fuel Temperature Sensor B Circuit Range/Performance
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 11545 Code
- Inspect all the connections data-bus powertrain, software version controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns