VW Code 11478
11478 Description And Summary : |
|---|
The problem is about transmission output speed sensor 2 (g196), no signal It could be due to limited air getting through your air intake givers 2 for intake air temperature (g299), signal too small . On the other hand exhaust bank 1 sensor 1 o2 sensor signal, implausibly lean will delay your vw fault. |
11478 Possible Causes:
11478 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 11478 Code
- Inspect all the connections a/c request b, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns