VW Code 11446
11446 Description And Summary : |
|---|
The problem is about event data recorder request, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so butterfly valve drive 2 (g296) of electrical errors in the electric circuit and wait then o2 sensor signal bank 2 sensor 1, biased / stuck lean will delay your vw fault. |
11446 Possible Causes:
11446 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Rail Pressure Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 11446 Code
- Inspect all the connections radiator exhaust control 2, short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns