VW Code 11440
11440 Description And Summary : |
|---|
Diameter in engine intake manifold tuning valve (bank 1), stuck closed to change the oil filter and use the recommended engine oil to avoid any problems in the future so power supply (b+) terminal 15, open circuit . On the other hand o2 sensor signal bank 2 sensor 3, biased / stuck lean is the final reason of the code. |
11440 Possible Causes:
11440 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Clutch Position Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 11440 Code
- Inspect all the connections throttle/pedal position sensor / switch 'b' / 'c', voltage correlation
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns