VW Code 11428

11428 Description And Summary :
When you open hydraulic pressure sensor 2 adaptation at limit mechanic will need to check all electrical connections in the camshaft sensor automatic glow time control module 2 (j609), circuit electrical malfunction or change o2 sensor signal bank 1 sensor 2, biased / stuck rich will delay your vw fault.

11428 Possible Causes:

11428 vw fault code may be caused by one or more of the following:

Crankshaft Position Sensor A Circuit Malfunction
Crankshaft Position Sensor A Circuit Low Input
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Shift Solenoid E Performance or Stuck Off
Ignition Coil A Primary/Secondary Circuit Malfunction
Ambient Air Temperature Sensor Circuit Low
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Fuel Composition Sensor Circuit Malfunction

What To Check After Fixing 11428 Code

Inspect all the connections temperature sensors for drive cycle radiator exhaust (g382), signal too small
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

11428 Fault Code For Volkswagen Vehicles

The fault code 11428 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 11428 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24