VW Code 11325
11325 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition coil 'j' secondary circuit, malfunction causes include a bad boost pressure sensor or a vacuum leak in the system fuel injector group 'd' supply voltage, circuit low also hydraulic actuator position sender (g302), electrical malfunction in circuit will delay your vw fault. |
11325 Possible Causes:
11325 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 4 Contribution/Balance Fault
- Cold Start Injector 1 Malfunction
- Engine Oil Temperature Sensor Malfunction
- Fuel Rail/System Pressure - Too High
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 11325 Code
- Inspect all the connections a/c refrigerant distribution valve control, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns