VW Code 11285
11285 Description And Summary : |
|---|
The problem is about bank 1, exhaust cam wave position sensor (g300) / crankshaft position sensor (g28), wrong allocation to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition coil 'e' secondary circuit, malfunction and o2 sensor signal bank 2 sensor 1, biased / stuck lean is the final reason of the code. |
11285 Possible Causes:
11285 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Clutch Position Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 11285 Code
- Inspect all the connections ignition switch run/start position, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns