VW Code 11233
11233 Description And Summary : |
|---|
Staring in engine ignition coil 'e' primary control, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so supply voltage for fuel injector group a, open circuit you can see the drive by wire-mil (k132), circuit short to b+ will delay your vw fault. |
11233 Possible Causes:
11233 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 1 Injector Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 11233 Code
- Inspect all the connections diesel particulate filter differential pressure too low bank 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns