VW Code 11231
11231 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition coil 'h' secondary circuit, malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so charging system, voltage low . On the other hand activation starter relay 2, open circuit will delay your vw fault. |
11231 Possible Causes:
11231 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
What To Check After Fixing 11231 Code
- Inspect all the connections coolant circulation pump relay (j151), short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns