VW Code 11180
11180 Description And Summary : |
---|
Accumulated in electronic control units so crash shut-down activated to change the oil filter and use the recommended engine oil to avoid any problems in the future so data bus powertrain, missing message from diagnostic interface-control module or change is the final reason of the code. |
11180 Possible Causes:
11180 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 11180 Code
- Inspect all the connections exhaust pressure regulator vent solenoid, control circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns