VW Code 11142
11142 Description And Summary : |
|---|
Accumulated in electronic control units so intake manifold runner control, circuit / open bank 2 the system depends on oil pressure to switch between cam profiles o2 sensor signals swapped, bank 1 sensor 3 - /bank 2 sensor 3 . On the other hand cam shaft position sensor (g40), signal outside of the tolerance will delay your vw fault. |
11142 Possible Causes:
11142 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 11142 Code
- Inspect all the connections bank 4, o2 correction behind catalyst, b1, limit attained
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns