VW Code 11136
11136 Description And Summary : |
|---|
This code were stamped on VW Engine case kick down switch malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle actuator control system, stuck closed . On the other hand exhaust bank 3, probe 1 tension too largely is the final reason of the code. |
11136 Possible Causes:
11136 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 11136 Code
- Inspect all the connections load signal stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns